Epson wf 7710 serial#
Epson wf 7710 manual#
Epson wf 7710 series#

If ink comes into contact with your skin, wash it off with soap and water immediately. Never touch the ink or wasted ink with bare hands. Doing so may cause ink to leak from the product because it may take some time for the waste ink pads to completely absorb ink wasted due to the ink charge.Д©. Do not tilt this product immediately after initial ink charge, especially after performing the ink charge several times. In order to protect sensitive microprocessors and circuitry, use static discharge equipment, such as anti-static wrist straps, when accessing internal components.ДЁ. пЃ® When connecting cables/FFC to the connectors on circuit boards, connect them straight to the connectors to avoid slant insertion.Д§. пЃ® When handling FFC, take care not to let the terminal section of FFC touch metal parts. To prevent the circuit boards from short-circuiting, be careful about the following when handling FFC or cables. There is a risk to damage the Main Board if the Head FFC is short-circuited with the capacitors on the Main Board electrically charged, therefore, after the power turns off or after motors are driven, leave the printer untouched for approximately 30 seconds to discharge the capacitors before starting disassembly/ reassembly.Д¦. The capacitors on the Main Board may be electrically charged right after the power turns off or after driving motors which generates counter electromotive force such as when rotating the PF Roller or when moving the CR Unit. Replace malfunctioning components only with those components provided or approved by Epson introduction of second-source ICs or other non-approved components may damage the product and void any applicable Epson warranty.ДҐ. Never connect this product to the power source whose voltages is different from the rated voltage.Д¤.

Epson wf 7710 serial#

The power rating of this product is indicated on the serial number/rating plate. No work should be performed on this product by persons unfamiliar with basic safety knowledge required for electrician.ДЈ. Repairs on Epson product should be performed only by an Epson certified repair technician.Дў. Failure to comply may lead to personal injury or damage of the product.ДЎ.

When using compressed air products such as air duster, for cleaning during repair and maintenance, the use of such products containing flammable gas is prohibited. If any ink gets in your eyes, wash your eyes with clean water and consult a doctor immediately.Дў. Always wear protective goggles for disassembly and reassembly to protect your eyes from ink in working. Failure to comply may lead to personal injury or loss of life.ДЎ. If you need to perform the work with the power cable connected to a power source, use extreme caution to avoid electrical shock. Connecting to a power source causes high voltage in the power supply unit and some electronic components even if the product power switch is off. When performing works described in this manual, do not connect to a power source until instructed to do so. Always disconnect the product from the power source and peripheral devices when servicing the product or performing maintenance.Дў. Failure to comply could result in serious bodily injury or loss of life.ДЎ. EPSON disclaims any and all rights in those marks.ДЄll safety procedures described here shall be strictly adhered to by all parties servicing and maintaining this product. Note :Other product names used herein are for identification purpose only and may be trademarks or registered trademarks of their respective owners.

Epson wf 7710 manual#

пЃЇ The above not withstanding SEIKO EPSON CORPORATION can assume no responsibility for any errors in this manual or the consequences thereof.Д®PSON is a registered trademark of SEIKO EPSON CORPORATION. пЃЇ The contents of this manual are subject to change without notice. However, should any errors be detected, SEIKO EPSON would greatly appreciate being informed of them.

пЃЇ All effort have been made to ensure the accuracy of the contents of this manual. No part of this manual may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION.

6.2 Lubrication Points and Instructions.

5.2.3 Scanner Timing Belt Tension Check.

4.3 Detailed Disassembly/Reassembly Procedure for each Part/Unit.

4.2.1 Parts/Units Need to be Removed in Advance.

Epson wf 7710 series#

1.5.1.2 Forced Power OFF (WF-7010 series only).

1.3 Scanner Specifications (WF-7520/7510 series only).